Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Trusted Chimney Sweep for East New York Homeowners
Most chimney problems in East New York announce themselves quietly: a faint tar smell on a cold morning, a draft that wasn’t there last winter, black flakes on the hearth after a fire. By the time smoke backs into the room, creosote has usually been building for a season or two. Glazed, hardened creosote is the fuel that feeds a chimney fire, and a blocked flue can push carbon monoxide back into living space instead of up and out. Our technicians have up to 12 years of experience reading those signs and clearing them properly. We sweep on the same day when the schedule allows, and we inspect before we recommend anything. Call (855) 337-0826.
What Our Chimney Sweep Service Includes
Level 1 Inspection
A Level 1 inspection is the visual check that comes with a routine sweep. We examine the accessible parts of the firebox, damper, flue and cap, looking for creosote buildup, soot, cracks and obstruction. It’s the right call when your appliance and fuel type haven’t changed and nothing feels off, and it lets us confirm the sweep actually left the flue clean. Ask for it as a standalone service if you’d rather have the assessment before any cleaning.

Level 2 Inspection
A Level 2 inspection goes further, using a camera to look at the flue interior along its full length, including areas a flashlight can’t reach. You need one after a chimney fire, when you’ve changed appliances or fuel types, or when you’ve moved into a home whose chimney history you don’t know. We read the footage with you, point out what we see, and hand over a photo report so the findings don’t rest on our word alone.

Creosote Removal
Creosote is the residue left behind by wood smoke, and it ranges from loose soot to a hard, glazed coating that clings to the flue walls. We remove it with rotary brushes and scrape glazed deposits where the liner allows, then check the result with a camera before we call the job done. Left alone, that coating thickens each season and raises the risk of a chimney fire; once it’s gone, you can burn again with a clean flue.

Soot Removal
Soot is the fine, powdery fallout that settles on the smoke shelf, damper and firebox walls, and it drifts into the room on the first fire of the season when it’s left sitting. We remove it with HEPA-filtered vacuums so the work stays contained and the room doesn’t need a follow-up cleaning. This matters for oil-fired and gas appliances too, where soot and flue debris can clog the passages.
Annual Sweep
An annual sweep is the once-a-year cleaning and check most solid-fuel appliances need, and it’s how small issues get caught before they turn into liner work. We sweep the flue, clear the firebox and check the cap, crown and joints while we’re on the roof. When a chimney has been neglected longer than a year, we plan the sweep around what’s actually in the flue rather than a fixed time.
Fireplace Cleaning
Fireplace cleaning covers the firebox, hearth, glass doors and the masonry around the opening, where ash, soot and smoke staining collect. It’s the finish that makes a swept fireplace look and smell like it should, and it’s worth having done before the first cold snap. We clean the firebox and hearth by hand and vacuum the surrounding area, so the fireplace is ready to light the day we leave.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Brands We Service for Chimney Sweep
We work with the professional-grade materials the trade relies on, and that includes knowing the equipment behind them. Gelco and Olympia Chimney components show up on plenty of the caps, adapters and liners we service in East New York, and we know where those parts wear and where they hold up. Famco and Copperfield come up often on component-level work, and our access to those supply channels means the pieces we fit are the professional-grade ones, not big-box substitutes.
The same applies to the restoration end of the job. HeatShield’s liner resurfacing system lets us repair a failing flue without a full reline in the right conditions, and DuraFlex flexible liners handle the cases where a full reline is warranted. Those capabilities matter because most sweep-only companies can’t do either, so the work gets handed off mid-project. Whether your chimney has Gelco, Olympia Chimney, Famco, Copperfield or any other make on it, we can help.
Signs You Need Chimney Sweep Right Now
- A strong creosote smell, especially in warm weather. That tar-like odor means deposits have built up on the flue walls, and the smell gets stronger as the weather warms and the residue softens. It’s a sign the flue is overdue and worth a look before the next fire.
- Smoke backing into the room. Smoke that rolls out of the fireplace instead of drawing up the flue usually means a partial blockage, a soot-clogged smoke shelf, or a cap that’s blocked. It also puts combustion gases in the room, which is the real concern.
- Black soot flakes on the hearth or a darkened firebox. Fresh soot fallout after a fire points to poor draft and deposits flaking off the flue. It’s minor on its own, but it often shows the flue needs a sweep before it becomes a bigger cleanup.
- Animals or nesting debris around the cap. Birds and squirrels get into uncapped or damaged flues, and the nesting material blocks the flue and can ignite. A sweep and a look at the cap settle it.
- A chimney you haven’t had looked at since you moved in. If you don’t know when the flue was last swept, the safe assumption is that it hasn’t been recently. A Level 2 inspection answers the question properly.
Our Chimney Sweep Process – Step by Step
- 1
We ask about the appliance and the history. Wood stove, open fireplace, oil furnace or gas insert all change what we look for and how we sweep. We ask what you burn, how often, and whether the chimney has been through a fire, so the visit is planned around your system.
- 2
We protect the room before we start. Drop cloths go down around the hearth and we set up HEPA-filtered vacuums so soot stays in the machine. Nothing about a sweep should leave you cleaning the living room afterward.
- 3
We sweep the flue and clear the firebox. Rotary brushes sized to the flue clear soot and creosote, and we scrape glazed deposits where the liner permits. We clear the smoke shelf and damper as well, since that’s where blockages hide.
- 4
We inspect with a camera and check the outside of the system. A camera run through the flue shows us the liner’s condition, and we check the cap, crown and joints on the roof. This is where we find cracks and gaps that a sweep alone would miss.
- 5
We show you what we found and leave you a photo report. You see the footage, we explain what it means, and we say plainly whether any repair can wait or shouldn’t. A written estimate covers anything that needs doing, and you decide from there.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Sweep Cost in East New York?
A standard chimney sweep in East New York typically runs $150 – $300, and a Level 1 inspection done alongside it is usually included in that price. A Level 2 inspection with camera footage typically runs $250 – $500 depending on the flue’s length and condition. Creosote removal is charged within the sweep when the buildup is ordinary, but glazed third-degree deposits that need scraping run higher, often $400 – $800. Fireplace cleaning as a standalone job usually lands around $100 – $250. These are typical ranges for this market, and the written estimate sets the final price on every job.
What moves the number is the state of the flue, not the size of the house: heavy glazed creosote, a long or offset flue, an appliance that’s hard to reach, and whether the cap or crown needs attention all affect the total. The way to avoid overpaying is to ask for the camera evidence before agreeing to anything bigger than a sweep. Nothing we recommend goes past what the footage shows, and if a repair can safely wait a season, we’ll say so. Every estimate is free.
Chimney Sweep Near East New York – Our Service Area
We work across East New York and the neighborhoods around it, including Cypress Hills and Brownsville to the north and west. We also reach the homeowners we serve in Brighton Beach, Springfield Gardens, Rosedale and Cambria Heights, plus the Valley Stream and Five Towns areas to the east. A chimney sweep visit is booked around your schedule, with fast dispatch from 7am to 7pm, Sunday through Friday.
Serving East New York, NY – Our Local Coverage Area
We serve East New York and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Chimney Sweep in East New York
A chimney sweep is a professional cleaning of the flue and firebox to remove soot and creosote, followed by a visual check of the system. It’s not just brushing; a proper sweep includes clearing the smoke shelf, checking the damper, and looking at the cap and crown. We also run a camera through the flue so you know what condition the liner is in. Call (855) 337-0826 to book a sweep.
A standard sweep usually takes about 45 minutes to an hour and a half, depending on the flue’s condition and how much buildup is there. A Level 2 inspection with camera footage adds time, often a half hour or more. We protect the room first, so setup and cleanup are part of that window. Call (855) 337-0826 for an estimate on your chimney.
A typical sweep in East New York runs $150 – $300, with a Level 1 inspection usually included and a Level 2 inspection running $250 – $500. Glazed creosote that needs scraping can push the total higher, and fireplace cleaning on its own is often $100 – $250. The written estimate sets the final price. Call (855) 337-0826 for an exact quote; estimates are free.
Yes. We service Olympia Chimney and Gelco caps, adapters and liner components, and we know where those parts wear on a working chimney. We also work with Famco and Copperfield components and the HeatShield and DuraFlex systems used in liner restoration. Whatever make is on your flue, we can assess it and tell you what it needs. Call (855) 337-0826 to book an assessment.
Same-day service is often possible when the schedule allows, so call and we’ll tell you what’s open. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. We’re closed on Saturday, and a call outside dispatch hours is booked into the next opening. Call (855) 337-0826 to check availability.
The workmanship and materials we stand behind are covered, and the details are set out in writing on your estimate before any work begins. We use professional-grade materials from DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco and Copperfield, so the parts we fit are the trade-grade ones. If something isn’t right after the job, we come back and make it right. Call (855) 337-0826 to talk through your job.
Clear the hearth and the floor in front of the fireplace, and move anything fragile or fabric that could catch soot out of the way. Don’t light a fire for at least 24 hours before the appointment so the flue is cool and the deposits are settled. If you have a fireplace screen or glass doors, leave them in place; we’ll handle them. Call (855) 337-0826 to book your sweep.
Schedule Your Chimney Sweep Service in East New York Today
If your flue hasn’t been cleaned in a while, or you’ve noticed any of the signs above, book a sweep and get a straight answer about your chimney’s condition. We inspect before we recommend, we show you the camera footage, and the written estimate sets the price. Call (855) 337-0826. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep East New York.