Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Trusted Chimney Repair for East New York Homeowners
Chimney repair in East New York, NY is the work that stops a small masonry problem from becoming a rebuild: a crumbling mortar joint, a missing flashing edge, a crown that cracked over one winter. Left alone, each of those lets water into the brick, and freeze-thaw cycles in this part of Brooklyn finish the job. We’re a full-system chimney specialist, not a generalist, and our technicians have up to 12 years of experience reading exactly this kind of wear. We work with DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield materials, the same professional-grade lines certified sweeps specify. We inspect before we recommend, and repair is booked by written estimate. Call (855) 337-0826. We answer 24/7, with fast dispatch from 7am to 7pm.
What Our Chimney Repair Service Includes
Your chimney is a system, not just a flue. Masonry, flashing, crown, cap, and liner all depend on each other, so a fix that ignores one usually fails at another. Here’s what our repair work actually covers.
Mortar Repointing
Repointing means cutting out deteriorated mortar from the joints and replacing it with fresh, correctly matched mortar. You need it when joints have eroded or turned sandy, which opens the brick face up to water. We grind out to a uniform depth and pack new mortar so the repair bonds properly instead of sitting on top of loose material.

Spalling Brick Repair
Spalling is when a brick face flakes, peels, or pops off because moisture got inside and froze. It’s a structural signal, not a cosmetic one, and it tends to cluster on the side of the chimney that catches weather. We remove only the failed units, replace them with matching brick, and address the moisture source so the new brick doesn’t fail the same way.

Chimney Waterproofing
Waterproofing is a breathable vapor-permeable treatment applied to the masonry after repairs are done and the brick is clean. It’s the right call when the brick is sound but takes on water, which shows up as damp patches or efflorescence. We apply it after, never before, repair, because sealing a wet chimney traps the moisture you’re trying to keep out.

Flashing Repair
Flashing is the metal that seals the joint where the chimney passes through the roof. You need it repaired when you see rust streaks, lifted edges, or staining on the ceiling near the chimney. We reset or replace the flashing and counter-flashing so the joint is watertight against the roofing material, not just caulked over.
Chimney Rebuilding
Rebuilding applies when the masonry above the roofline has lost too much material to repair unit by unit. That means taking the stack down to sound brick and rebuilding with proper corbeling and a new crown. We evaluate whether a partial rebuild above the roof solves it or whether the damage runs deeper before we recommend scope.
Tuckpointing
Tuckpointing is the finer, finished version of mortar work, bringing a recessed or shaped joint to full profile for a cleaner face. It’s used on visible masonry where the joint treatment matters as much as the seal. We match mortar color and joint profile to the original where we can, so the repair doesn’t read as a patch.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Brands We Service for Chimney Repair
We work with Gelco and Olympia Chimney components as part of our repair and relining work, and we know where each wears out. Gelco systems are common on masonry and prefab chimneys where the terminations and caps take the weather first. Olympia Chimney liner and venting products show up on a lot of homes in this area, and we’ve learned to check the joints and connections first when a draft or water problem comes in.
Famco and Copperfield components come through professional supply channels, which matters on a repair because the fittings have to be right the first time. Famco and Copperfield product access reflects professional-supply relationships unavailable to generalist contractors, so we’re not forced to substitute a big-box part mid-job. We inspect and diagnose with the whole system in mind, then specify what actually fixes it. Whether you have Gelco, Olympia Chimney, or any other make, we can help.
Signs You Need Chimney Repair Right Now
- Crumbling or sandy mortar joints. When the mortar between the bricks recesses or you can rub it away with a finger, water is already getting in. Repointing now is a far smaller job than a rebuild later.
- Flaking or popped brick faces. Spalling brick means moisture has worked into the masonry and frozen. Left alone, the damage migrates to the sound units around it.
- Water stains or rust streaks near the chimney. Staining on the ceiling or rust on the flashing points to a failed joint at the roof. That’s a water problem you can usually catch before the framing is affected.
- A cracked or leaning crown. The crown sheds water off the top of the stack. When it cracks, water goes straight down the flue and into the masonry.
- White chalky powder on the brick (efflorescence). Efflorescence is mineral deposits left behind as moisture moves through the masonry. It’s a sign the chimney is taking on water and needs repair, not just a cleanup.
Our Chimney Repair Process – Step by Step
- 1
Inspection first. We start with a full inspection of the chimney system, including a camera look at the flue where it’s called for. That’s how we find out what’s actually failing, so we’re not recommending work off a guess.
- 2
Written findings. We walk you through what we found, with photos you can see for yourself. Nothing gets recommended without evidence you can verify, and we tell you plainly when a repair can safely wait.
- 3
Written estimate. You get the scope and price in writing before anything is booked. The estimate is free, and the written estimate sets the final price.
- 4
The repair. Repointing, brick replacement, flashing, crown, waterproofing, or rebuild, done with professional-grade materials from the brands we named. One contractor carries the whole system, so there’s no handoff to a second crew mid-project.
- 5
Final check. We confirm the repair is sound and the water paths are closed before we call it done.
Call (855) 337-0826 for a free estimate.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Repair Cost in East New York?
Chimney repair in East New York typically costs anywhere from about $150 for a small spot repair up to several thousand dollars for a rebuild, depending entirely on how much masonry has failed. Prices below are typical estimates for this area, not exact figures.
| Repair type | Typical East New York range | What drives the price |
|---|---|---|
| Spot mortar repointing | $150 – $500 | Number of joints, access |
| Spalling brick replacement | $300 – $900 | Number of units, matching |
| Flashing repair | $200 – $600 | Roof pitch, flashing type |
| Chimney waterproofing | $200 – $600 | Surface area, prep work |
| Crown repair or rebuild | $350 – $1,200 | Crack extent, crown size |
| Full chimney rebuild | $2,000 – $5,000+ | Height, damage depth |
What affects the price most is how far the water damage has gone before you call. Access matters too: a chimney on a steep roof or tight rowhouse setback takes more setup, and so does matching brick and mortar on older construction. You avoid overpaying by getting the inspection done first and asking for the camera evidence, so you can see the actual failure before any work is booked. Every free estimate here includes the inspection and a written scope, so you know what you’re paying for before you commit.
Chimney Repair Near East New York – Our Service Area
We serve East New York and the neighborhoods around it, including Cypress Hills, Brownsville, Rosedale, Springfield Gardens, Cambria Heights, and Cedarhurst. Over in Brighton Beach and Woodmere the masonry often shows the same weather-driven wear. We schedule repairs by written estimate, and your place in line depends on the scope, so the earlier we inspect, the sooner the work gets on the calendar. If you’re nearby, you’ll want to read our guide to Chimney Sweep East New York before your next sweep, and our pages on chimney repair in Brighton Beach and chimney repair in Springfield Gardens cover the same work in those areas.
Serving East New York, NY – Our Local Coverage Area
We serve East New York and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Chimney Repair in East New York
Chimney repair is the masonry and system work that restores a failing chimney: repointing mortar, replacing spalled brick, fixing flashing and crowns, waterproofing, and rebuilding the stack when needed. It’s more than cleaning a flue, because the parts that fail most are the brick, mortar, and joints that carry the weather. Repairs here are done with professional-grade materials from DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield. Call (855) 337-0826 for an exact quote. Estimates are free.
A spot repoint or flashing repair is typically a short job, done in a day. A full rebuild or a larger scope takes longer, because it runs in stages to let mortar and materials cure properly. The written estimate gives you the timeline for your specific repair. Call (855) 337-0826 for an exact quote. Estimates are free.
Most spot repairs in East New York run $150 – $900, while a crown repair or rebuild runs $350 – $1,200 and a full rebuild starts around $2,000 and goes up. The range depends on how far the water damage has gone and how much access the job needs. Getting the inspection first is how you avoid paying for work the chimney doesn’t need. Call (855) 337-0826 for an exact quote. Estimates are free.
Yes. We service Olympia Chimney and Gelco systems, along with Famco and Copperfield components, and we know where each tends to wear out. That means we can look at the specific fittings and connections before we recommend a repair. Whether you have one of these or any other make, we can help. Call (855) 337-0826 for an exact quote. Estimates are free.
Same-day repair is available, booked by written estimate. Our phone line is answered 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. We’re closed Saturday, and a call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. Call (855) 337-0826 for an exact quote. Estimates are free.
Yes. Our repair work is backed by a satisfaction guarantee. We inspect before we recommend anything, put the scope in writing, and confirm the repair is sound before we call it done. If a repair isn’t right, we come back and make it right. Call (855) 337-0826 for an exact quote. Estimates are free.
Clear access to the fireplace, the flue, and any attic or roof access point. Note any staining, moisture, or draft issues you’ve noticed so we can check those areas during the inspection. You don’t need to do anything to the masonry or the flue yourself. Call (855) 337-0826 for an exact quote. Estimates are free.
Schedule Your Chimney Repair Service in East New York Today
If the mortar is crumbling, the brick is spalling, or the flashing has let water in, get it inspected before the next freeze. We inspect before we recommend, so you’ll see the evidence yourself and get a written estimate with the price in it. Call (855) 337-0826 for a free, no-obligation estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep East New York.