Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Cap & Crown Cost in East New York?
Chimney cap installation in East New York typically runs $185 to $420, while a new crown averages $650 to $1,400. Rebuilding both together on a standard brick chimney usually lands between $1,100 and $1,900, and the written estimate you receive sets the final price.
Those numbers hold for most of the detached houses between New Lots Avenue and Linden Boulevard, where the housing stock is largely pre-war brick. What moves a job up or down is the size and condition of the masonry, not the cap itself. A cap is a small purchase; a crown is a masonry repair, and the two are priced very differently for good reason.
We answer 24/7 if you’ve got water coming down the flue right now. Fast dispatch from 7am to 7pm, Sunday through Friday. The estimate is free and priced per job.
Key Takeaways
- Cap-only work: $185 to $420 installed, depending on material and flue count.
- Crown replacement on a single flue: $650 to $1,400 typical.
- Cap and crown together, rebuild included: $1,100 to $1,900.
- Irregular flues, multiple flues and tall chimneys push cost upward.
- Avoiding the repair turns a crown problem into a liner problem, which costs more.
Chimney Cap & Crown Cost Breakdown (2026)
Here’s how the line items shake out for East New York in 2026. Every figure below is a typical range, not a quote.
| Item | Typical Range | Notes |
|---|---|---|
| Galvanized single-flue cap | $185 – $260 | Shortest lifespan, fine for a rental property |
| Stainless single-flue cap | $230 – $340 | The usual choice on an occupied house |
| Multi-flue stainless cap | $320 – $550 | Priced by flue count and footprint |
| Custom-fit cap for an irregular flue | $400 – $700 | Fabricated to the crown opening |
| Crown wash (thin coating over sound masonry) | $280 – $450 | Only when the existing crown is intact |
| Partial crown repair and patching | $400 – $750 | Cracked sections cut out and rebuilt |
| Full crown rebuild, one flue | $650 – $1,400 | Old crown removed, form set, new crown poured |
| Oversized or multiple-flue crown | $1,100 – $1,900 | Larger footprint, more formwork |
| Crown rebuild with cap installation | $1,100 – $1,900 | Standard combined job |
| Flashing repair alongside crown work | $250 – $600 | Added when the roof joint has opened |
| Masonry repointing at the crown shoulder | $300 – $800 | Spalled brick at the top courses |
Our technicians have up to 12 years of experience reading masonry, and what they look at first is the crown’s job: shed water off the top of the chimney and keep it out of the brick below. When a crown cracks, water gets behind it, freezes, lifts the brick, and the whole top of the chimney starts coming apart. Catching it at the crown is a masonry repair. Catching it at the liner is a relining job, and those don’t price the same.
The Cap and Crown Are Two Different Repairs
A cap is a manufactured component. It goes on top of the existing crown, covers the flue opening, and keeps rain, birds and squirrels out of the flue. It gets bolted or strapped to the flue wall or the crown surface. It’s a fast job, and the cost is dominated by the material.
A crown is poured masonry. It’s the sloping concrete or mortar cap on the very top of the chimney stack, and replacing it means removing the old one, setting forms, pouring a sloped crown that sheds water away from the flue, and finishing the edges so water doesn’t wick back under. That’s a different kind of work, which is why the price is a multiple of a cap.
Cap Materials and What They Cost to Install
The material choice is really a lifespan question. Galvanized steel is the cheapest and shortest-lived option; the coating goes first and then the metal underneath. Stainless steel costs more up front and holds up far longer in a climate with a real freeze-thaw cycle.
Stainless caps are what we install by default. Made-to-fit stainless caps work on almost any flue size, including the odd square and rectangular flues on older East New York chimneys. We source caps through Olympia Chimney, Famco and Copperfield, which are professional-supply lines rather than the generic caps sold in box stores. The difference shows in the screen gauge, the seams and the mounting method.
If you’d like the full picture on how we approach this work, see our page on chimney cap & crown.
What a Crown Rebuild Actually Involves
The old crown gets broken out down to sound masonry. Any spalled brick at the shoulder gets cut out and replaced. The flue is protected. We set a bond break so the new crown doesn’t bond rigidly to the flue and crack when the chimney expands, slope it so water runs off, and finish the drip edge. The new crown cures on the chimney, not in a shop.
HeatShield and Gelco crown materials are what we use because they’re formulated for exterior masonry exposure. HeatShield’s restoration products are specified by certified chimney professionals for a reason: they’re designed to work with the masonry, not just sit on top of it.
What Affects Chimney Cap & Crown Pricing in East New York
Two houses on the same block can price differently. Here’s what moves the number.
- Flue count. A single-flue chimney takes one cap. A chimney with two or three flues takes a larger cap or a multi-flue unit, and the crown footprint grows with it. This is the single biggest driver of variation in East New York, where the housing stock includes plenty of chimneys built for multiple appliances.
- Crown condition. A crown with a hairline crack and a crown that’s crumbling into the flue are not the same job. If the masonry under the crown is sound, a wash or a partial repair keeps the cost down. If the brick courses under the crown have spalled, that’s masonry work added to the estimate.
- Access and roof pitch. A chimney at the ridge on a steep roof takes more setup than one on a low-slope porch roof. Roof height and the condition of the roof surface around the chimney affect how the work is staged, and that’s reflected in the estimate.
- Freeze-thaw exposure. East New York sits where winter swings above and below freezing repeatedly, and that cycle is hard on masonry. Water that gets behind a cracked crown freezes, expands, and pries the brick apart. Chimneys fully exposed to wind are hit harder than ones sheltered by taller neighboring buildings.
- Existing flashing and mortar joints. A crown job often exposes a cracked flashing joint or loose mortar at the shoulder. It’s cheaper to repair those at the same time than to come back to them later.
- Cap spec. Galvanized, stainless, custom-fabricated, with or without a spark arrestor. The screening and mounting method matter more than most homeowners expect.
How to Save on Chimney Cap & Crown
Chimneys don’t reward deferral. The cheapest cap-and-crown job is the one done before the crown has failed, because the cost of a crown repair is usually less than a crown replacement plus liner work.
- Get the crown inspected before winter. A crack found in the fall is a crown repair. The same crack found in spring, after a winter of freeze-thaw, can mean liner damage too. A standalone inspection costs less than either repair, and we offer it as its own service so there’s no pressure to move straight into a fix.
- Combine the jobs. If you need a cap and a crown, do them together. The setup and access are already there, and the combined price is lower than two separate visits.
- Fix flashing at the same time. Roof-to-chimney flashing that’s already been disturbed is easier to reseal during a crown job than after.
- Don’t skip the cap because the crown is getting fixed. A rebuilt crown without a cap is open to rain and animals from the top down.
- Ask for the written estimate. Free estimates tell you exactly what’s being replaced and why. If a contractor can’t tell you why the crown is failing, that’s a sign the diagnosis is wrong.
Call (855) 337-0826 to book a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
FAQs – Chimney Cap & Crown Cost
How much does chimney cap and crown replacement cost in East New York?
Most jobs in East New York run $1,100 to $1,900 for a crown rebuild and new stainless cap together on a single-flue chimney. A cap alone is $185 to $420. Call (855) 337-0826 for an exact quote. Estimates are free.
Is it cheaper to repair a crown or replace it?
Repair is cheaper when the crown is intact and the crack is surface-level: a wash or patch typically runs $280 to $750. Once the crown has separated from the flue or the brick under it is spalling, replacement at $650 to $1,400 is the only repair that lasts. Call (855) 337-0826 and we’ll tell you which one you’re looking at.
What does a chimney cap cost on its own?
A stainless single-flue cap installed runs $230 to $340, and a multi-flue cap runs $320 to $550. Custom-fit caps for irregular flues come in at $400 to $700. Call (855) 337-0826 for a quote. Estimates are free.
What happens if I skip the crown repair?
Water gets behind the crown, freezes, and lifts the brick. The repair that starts at the crown ($650 to $1,400) can become a liner job in the $2,000 to $5,000 range once the water has reached the flue. Call (855) 337-0826 and we’ll inspect the crown before recommending anything.
Can you come today?
Often, yes. We answer 24/7 and dispatch from 7am to 7pm Sunday through Friday. A call outside dispatch hours is booked into the next opening. Call (855) 337-0826. Estimates are free.
Do I need a chimney sweep before a cap and crown job?
Not always, but for a chimney that hasn’t been swept recently, it’s worth doing first. A sweep and inspection tells us the condition of the flue, which affects whether a crown job is the only repair needed. Our chimney sweep East New York service runs separately from cap and crown work, and the estimate is set per job.
What kind of cap do you install?
Stainless steel caps made to fit the flue, sourced through Olympia Chimney, Famco and Copperfield. We don’t install galvanized caps on occupied homes unless a homeowner specifically asks for the budget option. Call (855) 337-0826.
Will my homeowner’s insurance cover a crown rebuild?
Sometimes. Most policies cover sudden damage from wind or a falling limb, not gradual deterioration from freeze-thaw. We can work with your insurer on documentation. Call (855) 337-0826 and we’ll walk you through what the inspection shows.
What does a chimney inspection cost?
Inspection is offered as a standalone service and priced separately from cap and crown work. It’s the first step before we recommend any repair. Call (855) 337-0826. Estimates are free.
Chimney Caps, Crowns and the Rest of the System
Your chimney is a system, not just a flue. The cap, crown, flashing, flue liner and firebox all depend on each other, and a failure in one accelerates wear in the rest. Rebuilding a crown without addressing a cracked flashing joint just moves the leak. Installing a cap without checking the liner means sealing moist air into a flue that can’t dry out.
That’s why we do cap and crown work as part of a full-system assessment. We use professional-grade components from DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco and Copperfield. When a DuraFlex liner or a HeatShield relining system is part of the fix, it’s done in the same visit.
If you want to understand the cap-and-crown work in more detail, see our page on chimney cap & crown, and for the flue-side of the system, the chimney sweep East New York service covers inspection and cleaning before any repair recommendation.
Book a Free Estimate
If your crown is cracked, your cap is missing, or you’re not sure which one is the problem, call (855) 337-0826. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Estimates are free and priced per job by the written estimate.
A cap and crown repair done properly costs less than a liner replacement. We inspect before we recommend, and we use the materials certified chimney professionals trust. One call, full system.
Pricing reflects the East New York market as of 2026. Chimney Sweep East New York offers free estimates – call (855) 337-0826.
What Our Customers Say
"Drop cloths everywhere, HEPA vac, and not a speck of soot on the carpet. I'd been dreading the mess for nothing."
- Carrie Meyer"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
- Jason Sullivan"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
- Marcy Kowalski