Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Trusted Chimney Cap & Crown for East New York Homeowners
A missing or cracked crown lets water straight into the masonry of the chimney, and a loose cap lets rain, birds, and squirrels down the flue. Those two small parts protect everything below them, which is why we treat chimney cap & crown work as structural, not cosmetic. Our technicians have up to 12 years of experience, and they inspect before they recommend, so you hear what the chimney actually needs and nothing more. If your cap is missing or your crown is breaking up, we can often schedule same-day service in East New York. Call (855) 337-0826. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
What Our Chimney Cap & Crown Service Includes
A chimney is a system, not just a flue. The crown caps the masonry at the top, the cap covers the flue opening, and the two work together to keep water and animals out. Here is what each piece of the job involves when we take it on in East New York.
Cap Installation
A chimney cap is the metal or mesh cover that sits over the flue opening and keeps rain, snow, birds, and squirrels out of the chimney. We install caps on flues that never had one, sizing the cap to the flue and anchoring it to the crown rather than wedging it loosely on top. We work with professional-only components from makers like Olympia Chimney, so the cap is built for the wind loads a roofline here actually takes.

Cap Replacement
A cap that has rusted through, lost its mesh, or blown loose in a storm needs replacing rather than patching. We pull the old cap, check the flue tile and crown underneath for damage the failed cap may have allowed, and fit a new cap matched to the flue’s dimensions. If the flue tile is cracked, we tell you before we install anything on top of it.

Crown Repair
The crown is the sloped concrete or mortar surface at the top of the chimney that sheds water away from the masonry below. Hairline cracks are normal as a crown ages; wide cracks, a crown pulling away from the flue, or chunks missing are not, because water gets behind them and freezes inside the brick. We repair the crown so water runs off the way it should, which protects the chimney from the freeze-thaw cycle that does the real damage in this climate.

Crown Coating
Crown coating is a flexible, weather-resistant layer applied over a crown that is sound but showing surface wear. It seals the small cracks and pitting that let water in while the crown underneath is still structurally intact. We use Gelco crown coating materials because a coating is only as good as its adhesion, and a coating that peels just traps moisture against the concrete.
Multi-Flue Cap
A multi-flue cap covers two or more flue openings under one housing, common on the larger chimneys and older rowhouses around East New York. We measure every flue opening and the spacing between them so the cap sits level and vents all flues properly. A poorly sized multi-flue cap is one of the most frequent causes of a smoking fireplace, so we check draft before and after.
Custom Cap
When a chimney has an unusual flue layout, a wide stack, or a shape that stock caps won’t fit, a custom cap is fabricated to the actual measurements. We take the dimensions on site, including flue tile thickness and crown slope, and order a cap built for that specific chimney. Custom work takes a little longer than a stock replacement, but it fits right the first time and stays put.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Brands We Service for Chimney Cap & Crown
We work with Gelco crown coating products, and we know how that coating behaves on the sun-exposed crowns and the shaded north-facing stacks that age very differently in this part of Brooklyn. We also work with Olympia Chimney caps and components, so we understand where those caps fatigue and how the mounting hardware holds up over a few winters of freeze and thaw.
For masonry-side work we rely on Famco and Copperfield components, the professional-supply lines that hold up where big-box substitutes don’t. Whether your chimney already carries one of these brands or any other make, we can help.
Signs You Need Chimney Cap & Crown Right Now
- Water stains on the ceiling or chimney breast. Brown rings after heavy rain usually point to a failed crown or a missing cap letting water into the masonry. Left alone, the water works through the brick and into the house.
- Cracks or crumbling on the crown. If you can see cracks from the ground, or pieces of concrete are landing on the roof, the crown is failing. Water is likely getting behind it already.
- A missing or damaged cap. A cap that has blown off, rusted through, or lost its mesh leaves the flue open to rain and animals. That’s a straightforward fix but it needs doing before nesting season.
- Animals or debris in the chimney. Scratching, bird calls from the flue, or a smell of droppings near the fireplace all point to a missing cap. The cap solves the entry problem; a sweep clears whatever already got in.
- Smoke backing into the room. A poorly fitted or oversized cap, or a blocked flue underneath one, can cause draft problems and smoke spillage. We diagnose the cause before we recommend a fix.
Our Chimney Cap & Crown Process – Step by Step
- 1
On-site inspection. We look at the crown, the cap, the flue tiles, and the masonry from the roof, and photograph anything we find so you can see it for yourself. Nothing gets recommended without camera evidence you can look at.
- 2
Written estimate. We give you a flat-price sweep agreed before booking, and the written estimate sets the final price. If part of the job can safely wait, we say so plainly.
- 3
Prep and protection. Before any repair work starts, we protect the roof and the area around the chimney. Crown work involves concrete and mortar, and cleanup is part of the job.
- 4
The repair or installation. We repair or recast the crown, install or replace the cap, or both, using professional-grade materials matched to the chimney. Cap and crown are fitted to the flue as it actually is, not to a nominal size from a catalog.
- 5
Photo report and final check. We finish with a camera inspection and a photo report of the completed work, plus a note on anything to watch over the next season. A satisfaction guarantee stands behind the work.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Cap & Crown Cost in East New York?
Pricing depends on the size of the chimney, the condition of the crown, and whether it’s a simple replacement or a full repair. Typical estimates in East New York:
- Standard chimney cap installation: $250 – $550
- Cap replacement, including removal of the old cap: $300 – $650
- Crown repair, small to moderate cracks: $350 – $750
- Crown coating on a sound crown: $300 – $600
- Multi-flue or custom cap: $500 – $1,200
What moves the price: the number of flues, the height and pitch of the roof, whether the crown needs a full recast versus a repair, and whether the flue tiles under the crown are also damaged. To avoid overpaying, ask for a written estimate with the cap and crown priced separately, and don’t accept a crown recast quote before someone has actually looked at the crown. Our estimate is free and includes a camera inspection and photo report, so you see exactly what you’re paying for.
Chimney Cap & Crown Near East New York – Our Service Area
We cover East New York and the surrounding neighborhoods, including Cypress Hills and Brownsville, and work across the nearby communities of Brighton Beach, Springfield Gardens, Rosedale, Cambria Heights, Cedarhurst, Woodmere, South Valley Stream, North Valley Stream, and Valley Stream. Dispatch runs Sunday through Friday, 7am to 7pm, and we can often reach same-day bookings. If your chimney needs chimney sweep East New York work alongside the cap and crown, we handle the full system on one visit.
Serving East New York, NY – Our Local Coverage Area
We serve East New York and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Chimney Cap & Crown in East New York
The crown is the sloped concrete or mortar top of the chimney that sheds water away from the masonry, and the cap is the metal or mesh cover that sits over the flue opening. They’re separate parts with separate jobs: the crown protects the brick and mortar below, and the cap keeps rain and animals out of the flue itself. Both wear out over time, and both are worth fixing before water damage spreads. Call (855) 337-0826 for a free estimate.
Most cap installations and replacements take one to two hours, while crown repairs and coatings typically run a few hours depending on the size of the chimney. A full crown recast needs curing time before the chimney is used again, and we tell you that timeline in the written estimate. Multi-flue and custom caps may need a return visit once the cap is fabricated. Call (855) 337-0826 to book.
A standard cap installation typically runs $250 – $550, and crown repair typically runs $350 – $750, with the final price set by the written estimate. Factors like the number of flues, roof height, and whether the crown needs a full recast will move the number. The estimate is free and includes a camera inspection and photo report. Call (855) 337-0826 for an exact quote – estimates are free.
Yes, we work with Olympia Chimney caps and Gelco crown coating products, and we also use Famco and Copperfield components for masonry-side work. We understand how each of these materials behaves in the freeze-thaw cycle this region gets, which is what shortens the life of a poorly chosen cap or coating. If your chimney already has one of these brands, we can service or replace it to match. Call (855) 337-0826 to discuss your setup.
We can often schedule same-day cap and crown work in East New York, depending on the day’s bookings. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. Call (855) 337-0826 to book.
Yes, a satisfaction guarantee stands behind our cap and crown work. If something isn’t right with the installation or repair, we come back and make it right. The written estimate spells out the scope of the work and what the guarantee covers. Call (855) 337-0826 for details on your specific job.
Clear access to the fireplace and the area around the chimney, and make sure we can get to the roof safely. If you have a fireplace insert or a wood stove, let us know when you book so we bring the right equipment. Move anything fragile away from the hearth, and secure pets. Call (855) 337-0826 to book and we’ll walk you through the rest.
Schedule Your Chimney Cap & Crown Service in East New York Today
A failed cap or crown is one of the least expensive chimney problems to fix and one of the most expensive to ignore. We inspect before we recommend, give you camera evidence and a photo report, and set the final price in writing. Call (855) 337-0826. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. The estimate is free and there’s no obligation.
Written by the team at Chimney Sweep East New York.